21
3 Getting Started
3.1 Unpacking and Handling
It is recommended that the NewStep Actuator and Motion Controller be
unpacked in your lab or work site rather than at the receiving dock. Unpack the
system carefully, small parts and cables are included with the instrument. Inspect
the box carefully for loose parts before disposing of the packaging. You are
urged to save the packaging material in case you need to ship your equipment.
3.2 Inspection for Damage
NewStep Actuator and Motion Controller have been carefully packaged at the
factory to minimize the possibility of damage during shipping. Inspect the box
for external signs of damage or mishandling. Inspect the contents for damage. If
there is visible damage to the instrument upon receipt, inform the shipping
company and Newport Corporation immediately.
WARNING
Do not attempt to operate this equipment if there is evidence of
shipping damage or you suspect the unit is damaged. Damaged
equipment may present additional hazards to you. Contact
Newport technical support for advice before attempting to plug
in and operate damaged equipment.
3.3 Parts List
The following is a list of parts included with the NewStep Actuator and Motion
Controller unit:
1. NewStep Actuator
2. NewStep Controller
To Next Page
Loading...
