Newport NewStep NSA12 - Figure 10 Initializing Another Controller Dialog Box; Figure 11 Scan Controllers Screen

36 Software
.
Figure 10 Initializing another Controller dialog box.
After all Controllers are initialized, “Scan Controller” window will open.
Select the range of controller numbers to scan for. The maximum range is from 1
to 255.
NOTE
Note that the time taken to scan the bus is proportional to the maximum scan
controller addresses selected.
Also, if the check box in the bottom is checked, the program will not scan the
RS485 network the next time the program is started
.
Figure 11 Scan Controllers screen
Position text
box