22 Getting Started
3. Power cord/Power supply
4. User’s Manual
If you are missing any hardware or have questions about the hardware you have
received, please contact Newport.
3.4 Choosing and Preparing Work Surface
The NewStep Actuator and Motion Controller may be placed on any reasonably
firm table or bench during operation.
3.5 Electrical Requirements
NewStep Actuator and Motion Controller use low-noise linear AC-DC power
supplies to provide internal power. The power supply is auto-sensing for
voltages ranging between 100-240VAC, 1.5A at 50/60Hz.
Have a qualified electrician verify the wall socket that will be used is properly
polarized and properly grounded.
3.6 Operating Temperature
NewStep Actuator and Motion Controller are designed for operation in a
laboratory environment. Recommended ambient operating temperatures are
between 20 - 25°C. Operation at higher or lower ambient temperatures for
limited periods (e.g. several hours) will not cause any harm but may slightly
reduce the performance.
To Next Page
Loading...
