Software
35
After selecting the Port, if the Program finds any Uninitialized
Controllers(Controller address equal to zero), the “Initialize Controller” window
will open. The user then has to choose a valid controller address (a non-zero
value) that has not been assigned to other controllers.
NOTE
When initializing, only one Uninitialized Controller may be connected to the network
at a time. After specifying a Controller address and the Controller is initialized, other
Uninitialized Controllers may be connected, one at a time, and the “Initialize
Controller” Window will open again every time.
Figure 9 Initializing Controller screen
The program will ask if you want to initialize another Controller.
To Next Page
Loading...
