Newport NewStep NSA12 - Page 67

Command Set
67
ST stop motion
USAGE
IMM
♦
MIP
♦
SYNTAX
xxST
PARAMETERS
Description xx
[ int ]
-
Controller number
Range xx
-
0 to 255
Units xx
- None
Defaults xx
missing: none
out of range: none
DESCRIPTION
This command stops a motion in progress using deceleration rate
programmed with AC (set deceleration) command on the specified
controller.
RETURNS This command has no return value.
REL.
COMMANDS
MO
- Motor ON/OFF
EXAMPLE
41ST
| Stops the motion of the actuator on
controller 41