XPS-D Controller Start-Up Manual
For Split power entry version:
• Terminate the provided C19 plug to an AC line cord and connect it into the
“MOTOR DRIVE” cable receptacle.
• Connect a standard C13 AC line cord in the “CONTROLLER” cable receptacle.
• These connections must remain accessible by the user.
Figure 14: Split power entry line connections.
WARNING
The AC mainline(s) must include a protective earth.
NOTE
Power Input: 100–240 V, 60/50 Hz, 10–6.9 A
3.4.4 Power ON
• Turn the Main Power Switch to ON (located on the Rear Panel).
• For Split power entry version, turn on both AC supply lines (in any order).
• There is an initial beep after power on and a second beep when the controller has
finished booting. If the controller boots properly, the second beep is happy-
sounding, otherwise the sad-sounding beep is emitted. The time between the first
and the second beeps is approx. 20 seconds.
• There is also an Inhibit switch with a BNC connector in the rear of the XPS. The
Inhibit switch is directly linked by hardware to cut off motor power supply.
3.5 Connecting to the XPS
XPS supports 10/100/1000 Mbps Ethernet networking and can be accessed through:
1. Direct connection PC-to-XPS.
The Ethernet plugs “REMOTE” or “HOST” can either be used.
The plug “REMOTE” has a fixed IP address (192.168.254.254). The DHCP server
active on this plug will automatically configure the connected computer to make it
ready for communication with the XPS controller.
15 EDH0395En1031 – 09/18
To Next Page
Loading...
