Newport XPS-D - Front Panel - I;O Control; Front Panel - Device Status; Device Status - Positioner Errors

XPS-D Controller Start-Up Manual
The “HOST” plug has an adjustable IP address (192.168.0.254 upon delivery). This
plug require the connected computer to be set to a compatible IP address value.
2. Network connection.
The Ethernet plug identified “HOST” must be used to connect the XPS controller to
a Network. Before connection, the controller IP setting must be set by the Network
administrator.
The two following cables are provided with the motion controller.
3.5.1 Cross-Over Cables (Gray)
Standard Ethernet cross over cables are required when connecting the device directly to
the Ethernet port of a PC.
NOTE
Cross-over cables are typically labeled (cross-over or XO) at one or both ends.
Figure 15: Ethernet cross-over cables.
3.5.2 Straight Through Cables (Black)
Standard Ethernet straight through cables are required when connecting the device to a
standard network hub or switch.
Figure 16: Straight through cables.
EDH0395En1031 – 09/18 16