XPS-D Controller Start-Up Manual
• Go to the TERMINAL window, click on the Reboot function, then press the OK
button:
• Wait for controller to reboot, open the internet browser and connect again to
REMOTE
You can see the dynamic IP address in Controller → General.
The IP address delivered by your DHCP is displayed above.
• In case the XPS cannot negotiate an IP address from the DHCP the displayed
address will be 0.0.0.0. In that case contact your IT department.
• Remove the REMOTE cable and, if needed, configure your PC back to its original
Ethernet configuration, you have saved before modification.
EDH0395En1031 – 09/18 22
To Next Page
Loading...
