Nexcom PEAK650VL2B - Page 38

Peak 650 User's Guide Rev. A October 2000
BIOS Setup
4-22
Power Management
This category allows you to select the type (or degree) of power saving and is directly related to the
following modes:
1. HDD Power Down
2. Doze Mode
3. Suspend Mode
There are four selections for Power Management, three of which have fixed mode settings.
Disabled (default) No power management. Disables all four modes
Min. Power Saving Minimum power management. Doze Mode = 1 hr. Standby Mode = 1 hr.,
Suspend Mode = 1 hr., and HDD Power Down = 15 min.
Max. Power Saving
Maximum power management --
ONLY AVAILABLE FOR SL CPU
. Doze
Mode = 1 min., Standby Mode = 1 min., Suspend Mode = 1 min., and HDD
Power Down = 1 min.
User Define Allows you to set each mode individually. When not disabled, each of the
ranges are from 1 min. to 1 hr. except for HDD Power Down which ranges from
1 min. to 15 min. and Disabled.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS Initial display power management signaling.
Video Off In Suspend
This determines the manner in which the monitor is blanked.
The Choice: Yes, No.
Suspend Type
Select the Suspend Type.
The Choice: PWRON Suspend, Stop Grant.
MODEM Use IRQ
This determines the IRQ in which the MODEM can use.
The Choice: 3, 4, 5, 7, 9, 10, 11, NA.