14 USB-Link™ 2 Wi-Fi Edition Installation and Setup Manual
Chapter 3 • Installing the Drivers and Setting Up the Device
Installation Process Outline
Step 1: Install the USB-Link™ 2 drivers (pg. 15).
Step 2: Connect the U
SB-Link™ 2 to the vehicle (pg. 24).
Perform one of the following:
• Connect your PC using a USB cable (p
g. 24)
•
Connect to your PC using Wi-Fi (pg. 25)
Step 3: Te
st the conn
ection between the USB-Link™ 2 and the vehicle using
the NEXIQ™ Device Tester (pg. 29)
i If you have questions about using this product, contact NEXIQ™ Cus-
tomer Support at (800
) 639-6774, or send us an e-mail at:
support@nexiq.com.
To Next Page
Loading...