Please read and follow the notes below for the safe operation of your Dash Cam within your vehicle.
- As per the installation instructions, you must install the camera so it does NOT obstruct the
drivers view of the road, preferably behind the rear view mirror.
- Whilst the camera clearly needs to view through the windscreen in an area swept by the
windscreen wipers, the camera should be installed so as not to intrude significantly within
the wiped area.
- A 40mm intrusion into the green wiped area is the maximum permitted by law.
- Do NOT mount the Dash Cam in front of the driver directly, as depicted by the red area
in the above illustration.
- When installing the Dash Cam in a vehicle, always place the device securely against the
windscreen and where possible conceal the power cable under trim. Make sure that the Dash
Cam power cable does not interfere with the drivers operating controls, such as the steering
wheel, pedals or gear levers.
- Do NOT mount the Dash Cam in front of an airbag field of deployment or in a position to
obscure any mirrors.
- Clean the windscreen at the point of location, prior to fitting the Dash Cam, to ensure
absolute adhesion.
- It is recommended NOT to operate the Dash Cam whilst driving.
- The automatic Start-Stop technology incorporated within the device negates any need to
operate the controls whilst driving.
Note:
- Adjust any settings or review recordings using the Cam Viewer APP, whilst stationery, not
whilst driving.
- Only use your smartphone / tablet whilst stationery, not whilst driving.
For Help and Support please call 02920 866 429
Positioning your Dash Cam
26