2 Shark HD 500 Series User’s Manual
Copyright 2020 Next Wave CNC - All Rights Reserved.
SHARK is the registered trademark of Next Wave CNC.
Ready2Control is copyrighted by Next Wave CNC.
Virtual Zero Unlimited is patented by Next Wave CNC.
All other trademarks are the property of their respective
owners. Information in this manual is subject to change
without notice.The most recent version of this manual can
be found at www.NextWaveCNC.com/downloads-links
Next Wave CNC, LLC,
info@nextwaveCNC.com
600 W. Boundary St.,
Perrysburg, Ohio 43551 USA
(419) 318-4822
Please read this manual carefully. It provides
important setup and operational information for
your SHARK CNC and software. This manual
has been written with the assumption that you
are experienced with the basic operation of a
computer as well as the technical knowledge
required to safely operate power tools.
To Next Page
Loading...
Need help?
General