8 Shark HD 500 Series User’s Manual
Emergency Switch
Registering your SHARK HD CNC
Step 1
Power up your SHARK CNC control box.
• The HD machines two power switches on the control
box.
• The SD machines have only one power switch.
Step 2
Once you power up your SHARK CNC, an opening screen
appears on the pendant. Click Continue.
Main power Switch
IMPORTANT. Always turn off the power switch(s) when
connecting or disconnecting any of the cables. Failure to do so
can cause damage to electrical components and is not covered
by the warranty.
To Next Page
Loading...
Need help?
General