NexusRace SW English
When you have taken the boat through the minimum 360 turn, press Stop. If you want
to pause (if waves comes up during deviation) press Pause and continue again when
the waves have disappeared.
Check the Autodeviation
This function is used to check your Autodeviation. Make a new Autodeviation in calm
sea (during the evening) as described in above.
NOTE, The Auto check for the HPC Compass version 1.0 can only be made from The
NXR or NX2 Multi Control instrument
Clear the Autodeviation
If you by any reason prefer to reset the deviation created by the Autodeviation function,
press Clear
Magnetic variation, VAR
Set the deviation direction first, i.e. [+] for East or [-] for West, then enter the magnetic
value in 1/10 of a degree.
Adjust the Compass alignment
This function is used when the Compass is giving a constant course error, i.e. it is not
mounted exactly aligned as the boat (there is no need to mount the transducer at the
boats centreline). Make sure that the local magnetic variation is entered before you
make the alignment adjustment, otherwise you are unable to see the difference
between local magnetic variation and alignment error. The Compass may be installed
reversed 180 , but never at perpendicular, or 90 relative the centreline.
To Next Page
Loading...
