NHS ODFS Pace V1 - Page 48

48
Wireless Information - ODFS
®
Pace XL
Description The ODFS
®
Pace XL contains an industry standard ZigBee
PRO compliant RF telemetry module, the ETRX3.
Contains RF transmitter
(FCC ID)
S4GEM35XA
Industry Canada (IC-ID) 8735A-EM35XA
Frequency band 2.4 to 2.483 GHz (2.4GHz ISM band)
Radiated power +8dBm
Wireless compliance The wireless module used has been designed to meet all
national regulations for worldwide use. The wireless module
complies with the requirements of the Radio Equipment Directive
(2014/53/EU) and complies with FCC CFR Part 15(USA)
meeting the requirements for modular transmitter approval as
detailed in FCC public notice DA00. 107. Transmitter.
Quality of service
The ODFS
®
Pace XL is designed and tested to have a
response rate of less than 100ms latency depending on system
configuration after the detection of a heel event.
Co-exsistence and
interference
The system has been stringently tested in a range of scenarios
showing that it is not susceptible to interference. However, there
is no guarantee that other wireless communication devices will
not interfere with wireless communications.
The module is also certied to European Certication (ETSI)
EN 300 328:V2.1.1 (radio) EN301 489-1 V2.1.1 (EMC) EN301
489-17:V3.3.1 (EMC) and IEC 60950-1:2005+AMD2:2013
Wireless
Communication
indications
On pausing the ODFS® Pace XL, the wireless connection is
conrmed by display of a battery level for the footswitch. If the
connection Is not found, the message ‘No WFS!’ is displayed
(pg.27 Clinician Manual, pg.24 User manual)
To connect an new footswitch or re-establish a failed
connection follow the procedure on pg.79-80 of the Clinician
Manual, pg.37-38 of the User Manual.
Security requirements No user security measures required. AES-128 hardware
supported encryption implemented. No patient identiable data
is transmitted or retained by the device.
6