Nibe AG-WT10 - Setting Transfer Frequency

Setting transfer frequency
The unit's receiver receives signals on the frequency 38 kHz. The remote
control, which is supplied with the unit, must be set to transfer the signals
to the same frequency as the receiver. Carry out the following:
■
Insert the batteries into the battery compartment.
■
Hold the menu button ( ) in for at least 7 seconds (until the ”menu”
function opens).
■
The display now shows 00. To select frequency, press repeatedly
until the number "38" appears on the display.
CC
■
Hold in again for at least 7 seconds, to exit the menu.
NOTE
This action must be repeated every time the batteries are replaced.
Removing batteries
■
Remove the cover.
■
Slide the battery to the negative terminal and pull
it out from the positive terminal's side (as illustrated
in the figure).
■
Remove the other battery in the same way.
13AG-WT10Chapter 3 | Remote control