3 Remote control
Before use
■
Remove the cover from the back of the remote control and check that
the four microswitches have been set as in the figure below:
NOTE
The remote control is set with default code 1 and does not usually have
to be changed.
If more than one unit is installed in the same room, code the units 1 - 4
with the remote control (see the procedure in the installer manual).
■
Insert two AAA 1.5 V-DC alkaline batteries and follow the polarity indic-
ated on the remote control. The time indicator on the display flashes.
■
Press the ST button and set the time. The remote control is now ready
for use.
The batteries last longer than six months depending on how often the
remote control is used. Remove the batteries if the remote control is not
used for long periods of time (longer than one month). Replace the bat-
teries when the indicator lamp for data transfer ( ) on the remote
control flashes or when the climate unit does not respond to the remote
control command.
The remote control batteries contain hazardous substances. When they
reach the end of their life, they must be disposed of in accordance with
applicable legislation.
AG-WT10Chapter 3 | Remote control12
To Next Page
Loading...
Need help?
General
