8 Care and maintenance
Regular checks
Your heat pump is, in principle, maintenance free and therefore requires
minimal care after commissioning. On the other hand, it is recommended
that you check your installation regularly.
If something unusual occurs, messages about the malfunction appear in
the display in the form of alarm codes on the indoor unit display. See error
code table on page 38.
NOTE
■
Aside from regular cleaning, maintenance actions must be performed
by service technicians.
■
Check that the climate unit is off and that the mains supply is discon-
nected, before carrying out further cleaning work.
■
Do not pour water onto the indoor unit during cleaning. This can
damage the internal parts of the unit and cause short-circuits.
Housing and grille
Clean the inner casing and grille of the unit with a vacuum cleaner brush,
or with a soft and dry cloth. If there are any spots on these parts, use a
damp cloth with a small amount of cleaning agent.
Caution
■
Do not use any solvents, cleaning agents or strong chemical substances.
Do not use boiling water to clean the indoor unit.
■
Some metal edges and fins on the climate unit are sharp. Take great
care when cleaning these.
■
The heat exchanger and other components on the outdoor unit must
be cleaned at least once a year. Contact installer.
AG-WT10Chapter 8 | Care and maintenance32
To Next Page
Loading...
