EasyManua.ls Logo

Nibe AG-WT10 - Troubleshooting and Fault Codes; Troubleshooting Common Issues

Nibe AG-WT10
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9 Disturbances in comfort
Caution
Do not use mobile telephones in the proximity of the climate unit as this
can interfere with the function of the unit. If this malfunction is indicated
(the function lamp – OPERATION lights, but the climate unit does not
work), reset normal function by disconnecting the mains supply for ap-
prox. 3 minutes using the main switch or plug. Now start the climate
unit again.
Troubleshooting
NOTE
Work behind covers secured by screws may only be carried out by, or
under the supervision of, a qualified installation engineer.
NOTE
In the event of action to rectify malfunctions that require work within
screwed hatches the incoming electricity must isolated at the safety
switch.
If the climate unit does not work normally, perform the following checks,
before contacting the installer.
The climate unit does not work at all
ActionPossible cause
Reset mains supply.Mains supply interrupted.
Contact installer.Circuit fuse blown or faulty.
Press the start button "ON/OFF".The start button is set to "OFF".
Replace the batteries.Discharged remote control batteries.
AG-WT10Chapter 9 | Disturbances in comfort36

Other manuals for Nibe AG-WT10

Related product manuals