Nibe AG-WT10 - Page 22

Example: function diagram in auto mode ( ) with room temperature set
to 23 °C:
ON
ON ON
∆ 1 H ∆ 1 H
MIN.
MAX.
A
B
C
C
B
A
27
26
25
24
23
22
21
20
19
NOTE
The climate unit changes function mode (from heating to cooling or
vice versa) when one of the following occurs:
■
ZONE A: changes if the temperature varies by at least 3 °C from the
value set on the remote control.
■
ZONE B: changes if the temperature varies by at least 1 °C from the
value set on the remote control one hour after the compressor has
stopped.
■
ZONE C: never changes if the temperature does not vary by more than
1 °C in relation to the value set in the remote control.
AG-WT10Chapter 4 | Function modes20