Docking14
FIGHTER 1320
FIGHTER 1320 can be installed in several different
ways, some of which are described below.
More docking options can be found at
http://www.nibe.se/dockning
General
Example FIGHTER 1320 docked with an
oil boiler/pellet boiler and water heater (floating condensing)
NOTE!
The safety equipment must be
installed in accordance with current
regulations for all docking options.
FIGHTER 1320 gives priority to hot water charging at
half power (heat pump module B) via a shuttle valve
(RV). When the water heater/accumulator tank
(VVB/ACK) is fully charged the shuttle valve (VXV)
switches over to the heating circuit. When there is a
heat requirement, module A starts first. For larger
requirements, module B takes care of the heating. The
boiler is connected automatically when the energy
demand exceeds the capacity of the heat pump and
the shunt (SV-P) is activated when the temperature on
the boiler sensor (PG) is above 55 °C.
If VVB/ACK is fitted with an immersion heater (IU) and
a junction box (K11) the Extra hot water function can
be used. A by-pass contactor is recommended.
A Heat pump module A
AV Shutoff valve
B Heat pump module B
BV Non-return valve
EXP Expansion tank with
necessary
safety equipment
FG Flow sensor
HR Auxiliary relay
/Contactor
with by-pass
KB-in Brine in
KB-outBrine out
PG Boiler sensor
RG Return sensor
RV Control valve
SF Particle filter
SV-P Shunt
SÄV Safety valve
UG Outside temperature
sensor
VBP3 Heating medium
pump 3
VVB Water heater
VVG Hot water sensor
VXV Shuttle valve
VVB/ACK Accumulator with
water heater
* A safety valve must be installed if the VPA is
equipped with an immersion heater.
Boiler
To Next Page
Loading...
