Affect hot water
With low price mode on "SG Ready", the stop temperature
for the hot water is set as high as possible with compressor
operation only (immersion heater not permitted).
In the case of overcapacity mode on "SG Ready", the hot
water is set to large demand mode (immersion heater per-
mitted).
NOTE
The function must be connected to two AUX inputs
and be activated in menu 7.4 "Selectable in/out-
puts".
MENU 4.2.5 - SMART PRICE ADAPTION™
Range
Here you select where (which zone) S735 is installed.
Contact your electricity supplier to find out which zone
digit to enter.
Affect heating
Alternative: on/off
Degree of effect
Setting range: 1 – 10
Affect hot water
Alternative: on/off
Degree of effect
Setting range: 1 – 4
This function can only be used if your electricity supplier
supports Smart price adaption™, if you have an hourly tariff
agreement and an active myUplink account.
Smart price adaption™ adjusts some of the heat pump’s
consumption over the day to those periods with the
cheapest electricity tariff, which can give savings if on an
hourly rate based electricity contract. The function is based
on hourly rates for the next day being retrieved via myUplink,
and an Internet connection and an account for myUplink
are therefore required.
You can choose which parts of the installation are to be af-
fected by the electricity price and to what extent; the higher
value you select, the greater the effect the electricity price
has.
NOTE
A value that is set high may result in increased
savings, but may also affect the comfort.
MENU 4.4 - WEATHER CONTROL
Activate weath. contr.
Setting range: on/off
Factor
Setting range: 0 – 10
You can select whether you want S735 to adjust the indoor
climate based on the weather forecast here.
You can set factor for outdoor temperature. The higher the
value, the greater the effect from the weather forecast.
Caution
This menu is only visible if the installation is con-
nected to myUplink.
MENU 4.5 - AWAY MODE
In this menu, you activate/deactivate "Away mode".
When away mode is activated, the following functions are
affected:
• the setting for heating is lowered slightly
• the hot water temperature is lowered if demand mode
"large” or "medium” is selected
• The AUX function "Away mode" is activated.
If you want, you can select for the following functions to be
affected:
• ventilation
• hot water circulation (accessory or use of AUX is required)
MENU 4.7 - ENERGY PRICE
Here you can use tariff control for your additional heat.
Here you can choose whether the system is to exercise
control based on the spot price, tariff control or a set price.
The setting is made for each individual energy source. Spot
price can only be used if you have an hourly tariff agreement
with your electricity supplier.
Set the lower tariff periods. It is possible to set two different
date periods per year. Within these periods, it is possible to
set up to four different periods on weekdays (Monday to
Friday) or four different periods on weekends (Saturdays
and Sundays).
MENU 4.7.1 - VARIABLE ELECTRICITY PRICE
Here you can use tariff control for the electric additional
heat.
Set the lower tariff periods. It is possible to set two different
date periods per year. Within these periods, it is possible to
set up to four different periods on weekdays (Monday to
Friday) or four different periods on weekends (Saturdays
and Sundays).
MENU 4.8 - TIME AND DATE
Set time and date, display mode and time zone here.
47Chapter 9 | Control - MenusNIBE S735
To Next Page
Loading...
