Manual test
Manuell test ------------------ -- -
Pump 1 0%
Pump 2 (eller ventil) 0%
Tank 0%
T1 _ _°C T2 _ _°C
T3 _ _°C T4 _ _°C T5 _ _°C
0DQXDO WHVWLQJ
3XPS
3XPS
႑
In manual testing, it is possible to test the outputs that
are active with the choice of system and extra functions
that are made. All temperature values are also displayed.
For sensors that are not connected, the maximum value
is shown.
႑
To activate an output select row with (+)or(-). Press
to activate the selection. Now press (+)or(-) to activate
the output.
႑
Speed controlled pumps start at the lowest set speed, set
in the menu “Settings” and increases up to 100% in in-
crements of 5% using (+).
Manuell test ------------------ -- -
Pump1 90%
Pump2 0%
Tank 0%
T1 _ _°C T2 _ _°C
T3 °C T4 °C T5 °C
0DQXDO WHVWLQJ
3XPS
3XPS
NOTE
When the menu is exited, the outputs return to the
relevant mode automatically.
႑
Press a few times to return to the main menu.
Extra
When you have selected the row "Extra", press to enter
the menu selection.
There are three extra functions to choose from.
(All extra functions are not available for all systems, see pre-
vious pages)
Default setting means that the extra functions are deactiv-
ated.
External heating
The function is designed to heat up the tank when solar en-
ergy is insufficient.
႑
External boiler
႑
Immersion heater (NOTE must not be powered directly
from the output relay, but via contactor that is controlled
by the relay.)
Example
Extra Funktion styr
pumpen för circulation
mot extern värmekälla
([WHUQDO KHDWLQJ IXQFWLRQ FRQWUROV WKH SXPS IRU
FLUFXODWLRQ DJDLQVW H[WHUQDO KHDW VRXUFH
Cooling
The cooling function is used to cool the tank down in the
event of high solar radiation. The function also allows the
transfer of heat to other heat storage (e.g. pool).
Example
Extra Funktion styr pump
att värma upp pool
7KH FRROLQJ IXQFWLRQ FRQWUROV WKH SXPS WR KHDW D
SRRO
13SCU 10
For the Installer
Menu Settings
To Next Page
Loading...
