Nibe SCU 10 - Reset Operating Time; Sensor Calibration; Time Graph Operation; Time Graph Temp

Reset operating time
([WUD
7XEH FROOHFWRUV
3URWHFWLRQ IXQF
)ORZ PHWHU
)ORZ OPLQ
)DFWRU\ VHWWLQJ
6HUYLFH
5HVHW RS WLPH
QR
QR
\HV

QR
႑
If you wish to reset operating times, press to activate
the row. Then select “yes” with (+).
႑
To return to the main menu press a few times.
NOTE
This function resets all total operating times.
Time graph temp
7XEH FROOHFWRUV
3URWHFWLRQ IXQF
)ORZ PHWHU
)ORZ OPLQ
)DFWRU\ VHWWLQJ
5HVHW RS WLPH
6HUYLFH
7LPH JUDI WHPS
P
QR
\HV

QR
QR
႑
To select the row "Time graf temp" press (+)or(-). Then
press
to activate the menu choice.
႑
Use (+) and (-) to change the time base. (Adjustable 1 to
60 minutes with default setting 5 minutes.)
႑
To return to the main menu press a few times.
Time graph operation
3URWHFWLRQ IXQF
)ORZ PHWHU
)ORZ OPLQ
)DFWRU\ VHWWLQJ
5HVHW RS WLPH
7LPH JUDI WHPS
6HUYLFH
7LPH JUDI RS K
\HV

QR
QR
P
႑
To select the row "Time graf op" press (+)or(-). Then
press
to activate the menu choice.
႑
Use (+) and (-) to change the time base. (Adjustable 1 to
48 hours with default setting 1 hour)
႑
To return to the main menu press a few times.
Sensor calibration
Kalibrering givare--
-
-- Givare T1
Givare T2
Givare T3
Givare T4
Givare T5
6HQVRU 7
6HQVRU 7
6HQVRU 7
6HQVRU 7
6HQVRU 7
r&
r&
r&
r&
&DOLE VHQVRUV
r&
In this sub menu it is possible to calibrate all temperature
sensors in the system.
NOTE
Check the temperature with a calibrated thermometer
before adjustment.
(Calibration range -3 °C to +3 °C with default value 0 °C)
SCU 1016
For the Installer
Menu Settings