"Cooling" means that you obtain cooling in the home in
hot weather. You can deselect this function when you
do not wish to have cooling in operation.
MENU 4.2 - PLUS FUNCTIONS
Settings for any additional functions installed in
SMO S40 can be made in the sub menus.
MENU 4.2.3 - SG READY
Here, you set which part of your climate system (e.g.
room temperature) will be affected on activation of "SG
Ready". The function can only be used in mains networks
that support the "SG Ready" standard.
Affect room temperature
With low price mode on "SG Ready" the parallel offset
for the indoor temperature is increased by "+1". If a room
sensor is installed and activated, the desired room
temperature is instead increased by 1 °C.
With over capacity mode on "SG Ready" the parallel
offset for the indoor temperature is increased by "+2".
If a room sensor is installed and activated, the desired
room temperature is instead increased by 2 °C.
Affect hot water
With low price mode on "SG Ready", the stop temperat-
ure for the hot water is set as high as possible with
compressor operation only (immersion heater not per-
mitted).
In the case of overcapacity mode on "SG Ready", the
hot water is set to large demand mode (immersion
heater permitted).
Affect cooling
With low price mode of "SG Ready" and cooling opera-
tion the indoor temperature is not affected.
With overcapacity mode on "SG Ready" and cooling op-
eration, the parallel offset for the indoor temperature is
decreased by "-1". If a room sensor is installed and activ-
ated, the desired room temperature is decreased instead
by 1 °C.
Affect pool temperature
With low price mode on "SG Ready", the desired pool
temperature (start and stop temperature) is increased
by 1 °C.
With over capacity mode on "SG Ready" the desired pool
temperature (start and stop temperature) is increased
by 2 °C
NOTE
The function must be connected to two AUX
inputs and be activated in menu 7.4 "Selectable
in/outputs".
MENU 4.2.5 - SMART PRICE ADAPTION™
Range
Here you select where (which zone) SMO S40 is in-
stalled.
Contact your electricity supplier to find out which
zone digit to enter.
Affect heating
Alternative: on/off
Degree of effect
Setting range: 1 – 10
Affect hot water
Alternative: on/off
Degree of effect
Setting range: 1 – 4
Affect pool temperature
Alternative: on/off
Degree of effect
Setting range: 1 – 10
Affect cooling
Alternative: on/off
Degree of effect
Setting range: 1 – 10
This function can only be used if your electricity supplier
supports Smart price adaption, if you have an hourly
tariff agreement and an active myUplink account.
Smart price adaption™ moves the heat pump's consump-
tion over 24 hours to periods with the cheapest electri-
city tariff, which gives savings for hourly rate based
electricity contracts. The function is based on hourly
rates for the next 24 hours being retrieved via myUplink
and therefore an internet connection and an account for
myUplink are required.
You can choose which parts of the installation are to be
affected by the electricity price and to what extent; the
higher value you select, the greater the effect the elec-
tricity price has.
NOTE
A value that is set high may result in increased
savings, but may also affect the comfort.
NIBE SMO S40Chapter 9 | Control – Menus46
To Next Page
Loading...
