Nice RMF3004 - Page 78

22
Indication of possible cloning
attempt
Line 1: CLONING? TX
Line 2: Serial number, trigger
counter (hexadecimal) and Remote
Control button number
(REC TX, REC TX+CTWB and
REC TX+TP modes only)
Indication of triggering device not
registered in the MG 3000 Module
Line 1: NOT REGIST. xx, where xx:
TX = Remote Control
CT = Proximity card
BM = Biometrics
SN = Password
TP = Passive Tag
TA = Active TAG
Line 2: Serial number, trigger counter
(Remote Control only) and Button/
Channel number of the triggered
device
Indication of trigger device not ena-
bled for the Receiver in question
Line 1: NOT HABILIT. xx, where xx:
TX = Remote Control
CT = Proximity card
BM = Biometrics
SN = Password
TP = Passive Tag
TA = Active TAG
Line 2: Serial number, trigger
counter (Remote Control only)
and Button/Channel number of the
triggered device
- ENGLISH -
78