DIGITAL AIR MICROMETER USERS MANUAL (Second Edition)
20
(4) Operation flow at settings mode
Shown here is about the settings mode operation.
① Whole, general, entire
●Selection of program number to perform settings
Please select the program number that you want to perform with the
▽ /
PROG
△.
Start the measurement with the selected program number afte
finishing settings change
●Saving of settings values
Please select with ▽ /
PROG
△.
Please select WRITE to save the settings values.
Settings values will be changed.
Please select CANCEL to cancel the settings values.
Returns to the previous settings values.
Normal
Detail▼▲
Normal▼
PROG
ＥＮＴ
System ▲
Normal
is selected
END
CANCEL
WRITE
PROG
ＥＮＴ
ＥＮＴ
ＲＳＴ
Detail
is selected
System
is selected
PROG[10]
～
PROG[ 1]
ＲＳＴ
for 2 seconds
ＳＥＴＳＥＴ
[Measurement mode]
PROG
ＥＮＴ
ＲＳＴ
Detail System
WRITE
CANCEL
PROG
ＥＮＴ
ＲＳＴ
ＲＳＴ
ＥＮＴ
ＲＳＴ
ＥＮＴ
ＲＳＴ
ＥＮＴ
ＲＳＴ
[Measurement mode]
●Selection of settings mode
Please select with ▽ /
PROG
△.
Settings change of the following are possible
ormal [Standard settings] --- master values, judgment limit values
Detail [Detailed settings] --- measurement range, display analysis function
System [System settings] --- display data, moving averages frequency
To Next Page
Loading...
Need help?
General