Nidec ID300 - Keypad Operation: Setup and Faults; Fault Condition Reset Procedure; Using the Keypad for Programming

www.usmotors.com
ID300/302 Integrated Motor Drive | Start Up Tips for the ID300/302
7
1.7 Drive Functions
The 0 Menu has been customized to allow easy access to most of the parameters that are commonly
changed by a user. 0 Menuwillbedi󰀨erentinyourunitversusthefactoryresetvaluesstoredinthe
ID300/302.
With the RTC keypad cable already connected to the RJ45 plug inside the ID300 and the jumper wire
installed from Terminal 6 to 8, follow the steps below to change any parameter value in the ID300/302:
1. Power up the unit.
The keypad will light up and display “READY”.
2. Press the Enter button to access Programming Mode.
The display will change to show a menu and parameter value.
3. Pressthearrowkeystonavigatetoaspecicparametermenu(from0–22).
The Left and Right arrow key decrease and increase the menu number respectively.
4. Inthespecicmenu,presstheUp and Down arrow keys to reach the exact parameter.
5. Press the Enter button.
Theright-mostdigitwillbeginashing.
Button Function
The Green button starts the motor.
The Red button stops the motor.
The arrows buttons to navigate the menu system and change the settings
once the parameter is selected.
The Enter button selects Parameter View or Edit Mode. It also saves a
parameter change.
When navigating in Parameter Viewtoaspecicvalue,presstheEnter
button to begin editing.
Use the arrow keys to change the parameter value. Then, press the
Enter button again to accept the change.
Used the Escape button to exit from the Edit Mode. Press this button to
return to the Main Screen.
The Main Screen is used to adjust the speed of the motor. The motor
input frequency can be changed using the arrow keys. Since the ID300 is
an asynchronous motor, it will operate at an RPM related to the frequency
setting, less the motor slip.