18
Multi-position XYZT Experiments
1. Enable the Z and Time options and set up these parameters as described above
2. Enable the XY check box in the ND Acquisition window
3. Here you can add multiple stage positions. Move to the position of interest and
select the check box under the Point Name column
4. Repeat this process to add multiple xy positions to the list
5. If you enable the Move Stage to Selected Point check box, when you select a
position in the list the stage will move to that point
6. To update a positions XYZ coordinates select it from the list, adjust the
focus/position on the microscope and then press the horizontal arrows that point
towards the XY and Z coordinates.
To Next Page
Loading...
