203
l
At values other than ±0.0, a Y icon will be displayed in the top
control panel and E will be displayed in the viewfinder after you
release the M button.
The current value for flash compensation can
be confirmed by pressing the M button.
Normal flash output can be restored by setting flash
compensation to ±0.0.
Flash compensation is not reset when the
camera is turned off.
A Optional Flash Units
The SB-910, SB-900, SB-800, SB-700, and SB-600 also allow flash
compensation to be set using the controls on the flash unit; the value
selected with the flash unit is added to the value selected with the
camera.
A See Also
For information on choosing the size of the increments available for
flash compensation, see Custom Setting b3 (Exp./flash comp. step
value, 0 313).
For information on choosing whether flash
compensation is applied in addition to exposure compensation when
the flash is used, see Custom Setting e4 (Exposure comp. for flash,
0 325).
For information on automatically varying flash level over a
series of shots, see page 139.
To Next Page
Loading...
