Nikon D4 - Attaching a Power Connector and AC Adapter

396
n
Attaching a Power Connector and AC
Adapter
Turn the camera off before attaching an optional power connector
and AC adapter.
1 Remove the battery-chamber cover.
Lift the battery-chamber cover latch, turn
it to the open (A) position (q), and
remove the BL-6 battery-chamber cover
(w).
2 Connect the AC adapter.
Pass the DC cable over the power
connector cable guide (q) and slide it
down until it is at the bottom of the slot,
and then insert the DC plug into the DC IN
connector (w).
3 Insert the power connector.
Fully insert the power connector into the
battery chamber as shown.