Nikon D70 - Camera Settings Reference Chart

172
Connections—Connecting to a Computer
Connecting the USB Cable
1
Turn the computer on and wait for it to start up.
2
Turn the camera off.
3
Connect the UC-E4 USB cable as shown below. Connect the camera
directly to the computer; do not connect the cable via a USB hub or key-
board.
Windows 2000 Professional, Windows Millennium Edition (Me),
Windows 98 Second Edition (SE), Mac OS 9
Do NOT select PTP when using the software provided with the camera under one of the
above operating systems. If the camera has been connected to a computer running
one of the above operating systems with PTP selected, disconnect the camera as de-
scribed below. Be sure to select Mass Storage before reconnecting the camera.
Windows 2000 Professional / Windows Me / Windows 98 SE
The Windows hardware wizard will be displayed. Click Cancel to exit the wizard, and
then disconnect the camera.
Mac OS 9
A dialog will be displayed stating that the computer is unable to use the driver needed
for the “NIKON DSC_D70” USB device. Click Cancel to close the dialog, then discon-
nect the camera.