81
k
3 Frame the photograph.
4 Take the photograph.
Self-timer mode: Press the shutter-release
button halfway to focus, and then press the
button the rest of the way down to start the
self-timer (note that the timer will not start if the camera is unable to focus or in
other situations in which the shutter can not be released).
The self-timer lamp
will start to blink.
Two seconds before the photograph is taken, the self-timer
lamp will stop blinking.
The shutter will be released ten seconds after the timer
starts.
Remote control mode: From a distance of 5 m
(16 ft.) or less, aim the transmitter on the
ML-L3 at either of the infrared receivers on
the camera (0 3, 5) and press the ML-L3
shutter-release button.
In delayed remote
mode, the self-timer lamp will light for about
two seconds before the shutter is released.
In quick-response remote mode, the
self-timer lamp will flash after the shutter has been released.
In remote mirror-
up mode, pressing the ML-L3 shutter-release button once raises the mirror; the
shutter will be released and the self-timer lamp will flash after 30 s or when the
button is pressed a second time.
To cancel shooting, select another release mode.
A Cover the Viewfinder
When taking photos without your eye to
the viewfinder, remove the DK-21 rubber
eyecup (q) and insert the supplied DK-5
eyepiece cap as shown (w).
This
prevents light entering via the
viewfinder interfering with exposure.
Hold the camera firmly when removing
the rubber eyecup.
DK-21 rubber eyecup DK-5 eyepiece cap
To Next Page
Loading...
