301
n
AF-assist illuminator does not light:
• AF-assist lamp does not light if AF-C is selected for autofocus mode (0 91) or if continuous-
servo autofocus is selected when the camera is in AF-A mode. Choose AF-S. If an option other
than H (auto-area AF) is selected for AF-area mode, select center focus point (0 94, 96).
• The camera is currently in live view or a movie is being recorded.
• Off selected for Custom Setting a7 (Built-in AF-assist illuminator) (0 210).
• Illuminator has turned off automatically.
Illuminator may become hot with continued use;
wait for lamp to cool down.
Beep does not sound:
• Off is selected for Custom Setting d1 (Beep; 0 215) > Volume.
• Camera is in quiet shutter-release mode (0 77) or movie is being recorded (0 57).
• Focus-mode selector is set to M (0 99) or AF-C is selected for autofocus mode (0 91).
• Release is selected for Custom Setting a2 (AF-S priority selection; 0 208).
Smudges appear in photographs: Clean front and rear lens elements.
If problem persists, perform
image sensor cleaning (0 284).
Sound is not recorded with movies: Microphone off is selected for Movie settings > Microphone.
The brightness of the image in the monitor differs from the exposure of photographs taken in live view:
• Center-weighted or spot metering is selected (0 105).
• The camera is in mode M.
• The subject is too bright or too dark.
• Active D-Lighting is in effect (0 139).
• The photograph is a long time-exposure (0 73).
• The flash is used (0 143).
Flicker or banding appears during live view or movie recording: Choose an option for Flicker reduction
that matches the frequency of the local AC power supply (0 237).
Bright bands appear during live view or movie recording: A flash or other light source with brief duration
was used during live view or movie recording.
Menu item can not be selected: Some options are not available in all modes.
To Next Page
Loading...
