F-3
Tips on Speedlight Care and Reference Information
En-03
F
Problem Cause Solution
0
The SB-5000
does not work
properly.
Microcomputer may have
malfunctioned if this occurs
even when fresh batteries are
properly installed.
• Remove the batteries
and insert them again,
keeping the SB-5000’s
power switch set to a
position other than [OFF].
• If the problem continues,
contact your retailer or
Nikon-authorized service
representative.
B-14
Nonstandard
display
Dials or buttons
do not operate.
Key lock is activated. Cancel key lock. B-8
The SB-5000
does not
operate.
Thermal cut-out is active.
Wait until the SB-5000 cools
down.
E-16
Warning indicators
Warning indicator Cause Solution
0
All operations have stopped
due to low battery power.
Replace the batteries. B-15
The ash function is
canceled, and all operations
except power ON/OFF and
menu settings have been
suspended because the
SB-5000 has overheated and
could become damaged.
• Allow the SB-5000 to
cool down, keeping
the SB-5000’s power
switch set to a
position other than
[OFF].
• If the cooling system
is canceled, activate
it in the setup menu.
B-22
E-16
To Next Page
Loading...
