15
The WR-R10/WR-T10
WR-1 units can be used with WR-R10 and WR-T10 wireless remote
controllers (available separately).
WR-T10WR-R10
WR-R10
WR-R10
WR-A10
WR-1 units must be in pairing mode before they can be paired with
WR-R10 or WR-T10 wireless remote controllers; pairing instructions
for the WR-1 are identical to those given on page 9, while those for
the WR-R10/WR-T10 can be found in the manual provided with the
devices. When selecting channels, note that the WR-R10/WR-T10
support channels 5, 10, and 15 only; set the WR-1 to the same chan-
nel as the WR-R10/WR-T10. Neither the WR-R10 nor WR-T10 off er
group selection. Select Group A when using a WR-1 with WR-R10
units; when a WR-T10 is used, it will control receivers in all groups.
To Next Page
