Subject to alterations Page 5 of 33
Electrical connection
All wiring (power supply, safety circuit breaker, etc.) must only be fitted by a qualified
electrician.
The system must be connected in accordance with the accompanying wiring diagram.
The system is supplied with a 1 m test cable for the CTS 602 control panel. The control panel must
be connected to the CTS 602 controls using twisted pair cable type 2x2x0.25mm
2
(max. length
50m).
The CTS 602 control panel should be installed in a dry, frost-free location. A temperature sensor
built into the control panel prevents further cooling of the building should the primary heating sys-
tem fail by switching the ventilation system off if control panel temperature falls below a preset
level.
Figur 1: CTS 602 Control Panel
To Next Page
Loading...
