INSTRUCTIONS FOR USE ENGLISH
9100001616 - SC250 9
07/2016
PARK PEDAL
NOTE
In order to facilitate the use of the park pedal (10),
slightly lift the front section of the machine by gaining
leverage with your hands on the handlebar (A, Fig.
1).
For parking/handling:
1. Putting your hands on the handlebar (A), slightly lift the front
section of the machine, then press the pedal (B, Fig. 1).
In this condition, the front wheels (11) are resting on the
oor and the brush/squeegee unit is lifted.
For washing/drying:
2. Putting your hands on the handlebar (A), slightly lift the
front section of the machine, then lift the pedal (C).
In this conditions, the front wheels (11) are retracted and
the brush/squeegee unit is resting on the oor.
SOLUTION TANK FILLING
CAUTION!
Use only low-foam and non-ammable
detergents, intended for automatic scrubber
applications.
WARNING!
When using oor cleaning detergents, follow
the instructions on the labels of the detergent
bottles.
To handle oor cleaning detergents, wear
suitable gloves and protections.
1. Remove the tank cover (12).
2. Remove the cap (A, Fig. 2) on the solution tank (B).
3. Fill the solution tank (B) with water, leaving a few
centimeters from the top.
The water temperature must not exceed 104 °F (40 °C).
4. Use the measurement mark on the cap (A) to mix the
solution.
The capacity to the mark is 30 ml, equivalent to a 0.5 %
solution when diluted in a full tank of water. Always follow
the dilution instructions on the label of the chemical product
used to prepare the solution.
5. Replace the cap (A) on the solution tank.
6. Replace the tank cover (12).
NOTE
Whenever the 2 LEDs on the solution push-button (3)
ash, stop the machine and ll the solution tank.
B
A
C
Figure 1
P100932
AB
Figure 2
P100933
A1 ENGLISH.indd 9 25/07/2016 08:30:03
To Next Page
Loading...
Need help?
General
