EasyManua.ls Logo

Nilfisk-Advance Advance SC250

Nilfisk-Advance Advance SC250
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTRUCTIONS FOR USE ENGLISH
9100001616 - SC250 11
07/2016
BATTERY CHARGE LEVEL
The battery charge level can be viewed on the battery icon
LEDs (5).
The battery charge percentage depends on the number of LEDs
lit, as shown in the gure 5.
When the rst left LED ashes (15 %), the machine will only run
for a few more minutes (this will depend on the characteristics of
the work to perform).
STOPPING THE MACHINE
1. Turn off the machine by pressing the switch (2).
2. Press the park pedal (10) to lift the brush/squeegee unit.
NOTE
If the machine is on but not working (without the
operator’s hands on the grip handles), it automatically
turns off after 2 minutes.
TANK EMPTYING
An automatic oat shut-off system turns off the vacuum system
when the recovery tank is full.
The vacuum system deactivation is signaled by a sudden
increase in the vacuum motor noise, and the oor is not dried.
When the recovery tank is full, empty it according to the
following procedure.
Recovery tank emptying
1. Turn the machine off and press the park pedal.
2. Drive the machine to the appointed disposal area.
3. Turn and use the handle (A, Fig. 6) to lift the tanks
container (B) from the machine.
4. Remove the cover (C) and empty the recovery tank; rinse
the tank with clean water at the end of the work.
Solution tank emptying
5. Perform steps 1 to 4.
6. Remove the plug (14) and empty the solution tank. Then,
rinse the tank with clean water.
7. Reinstall the tanks container (B) on the machine body
(16), rotate the handle (A) to the horizontal position and
reposition the tank cover (C).
MACHINE TRANSPORT/PARKING
1. Stop and turn off the machine, then press the pedal (10) to
lift the brush/squeegee assembly from the oor.
2. While holding the machine in this position, drive it to the
appointed parking area.
3. If necessary, in order to manually lift the machine, bend the
handlebar (24) and grip the handle (25), then transport the
machine to the area where it is to be parked.
15% 30% 45% 60% 80% 100%
Figure 5
P100936
A
B
C
Figure 6
P100937
A1 ENGLISH.indd 11 25/07/2016 08:30:04

Table of Contents

Other manuals for Nilfisk-Advance Advance SC250

Related product manuals