EasyManuals Logo

Nilfisk-Advance Advance SC6000 User Manual

Nilfisk-Advance Advance SC6000
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
GENERAL MACHINE TROUBLESHOOTING
Problem Possible Cause Remedy
Poor water pick-up
Worn or torn squeegee blades Reverse or replace
Squeegee out of adjustment
Adjust so blades touch oor evenly across entire
width
Recovery tank full Empty recovery tank
Recovery tank drain hose leak Secure drain hose cap or replace
Recovery tank cover gasket leak Replace gasket / Seat cover properly
Debris caught in squeegee Clean squeegee tool
Squeegee seal clogged or missing Clean or replace squeegee seal
Vacuum hose clogged Remove debris
Using too much solution Reduce ow via control panel solution button
Foam lter cover not seated Seat cover properly
Poor scrubbing performance
Worn brush or pad Rotate or replace brushes
Wrong brush or pad type Consult Advance Authorized Service Center
Wrong cleaning chemical Consult Advance Authorized Service Center
Moving machine too fast Slow down
Not using enough solution Increase ow via control panel solution button
Inadequate solution ow
or no solution
Solution tank empty Fill solution tank
Solution lines, valves, lter or trough
clogged
Flush lines, trough and clean solution lter
Solution turned OFF Activate ow via control panel solution button
Solution solenoid valve plugged or
defective
Clean or replace valve
(contact Advance Authorized Service Center)
Machine does not power ON Machine Battery Connector (10)
disconnected
Reset Emergency Stop Switch
Reconnect battery connectors
Tripped 10 Amp (CB1) circuit breaker (V) Check for electrical short circuit & reset
Blown Main Fuse 150 Amp (14) Replace Main Fuse 150 Amp
No FWD/REV wheel drive
Drive system speed controller
Check error fault codes
(contact Advance Authorized Service Center)
Emergency Stop Switch (U) activated,
display will show Emergency Stop
Activated Indicator (C20).
Reset Emergency Stop Switch
Brake(s) locked, if equipped Consult Advance Authorized Service Center
Poor Sweeping Performance
(Cylindrical System)
Hopper Full Empty and clean hopper
Brushes worn Replace brushes
Bristles have taken a set Rotate brushes
No Detergent Flow (EcoFlex
models only)
Empty detergent cartridge Fill detergent cartridge
Plugged or kinked detergent ow line
Purge system, straighten lines to remove any
kinks
Dry seal cap on detergent cartridge not
sealed
Reseat dry seal cap
Detergent pump Check pump, wiring and lines
Magnetic SmartKey Errors No Key Indicator (C21).
-No Magnetic SmartKey is present on
the SmartKey Reader (A).
Place an appropriate SmartKey onto the
SmartKey Reader.
Key Read Error Indicator (C22).
- Magnetic SmartKey present on the
SmartKey Reader (A) cannot be read.
Clean both the SmartKey and the SmartKey
Reader using a clean cloth. Depress the
SmartKey between your thumb and fore nger to
insure free movement of the magnet.
Restricted User Key Indicator (C23).
-Magnetic SmartKey present on the
SmartKey Reader (A) is not programmed
to be used with this machine.
Place a SmartKey that has been programmed
to be used with this machine onto the SmartKey
Reader.
revised 10/2022
A - 38 SC6000 - 56091161 4/2016
INSTRUCTIONS FOR USEA - ENGLISH

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance Advance SC6000 and is the answer not in the manual?

Nilfisk-Advance Advance SC6000 Specifications

General IconGeneral
BrandNilfisk-Advance
ModelAdvance SC6000
CategoryScrubber
LanguageEnglish

Related product manuals