Nilfisk-Advance BR 755

Other manuals for Nilfisk-Advance BR 755

Quick Start Guide32 pages

Questions and Answers

W
walterswilliamJul 31, 2025
Why is the Nilfisk-Advance Floor Machine not picking up water well?
- J
  Jennifer MitchellJul 31, 2025
  Poor water pick-up in your Nilfisk-Advance Floor Machine can stem from several causes: * Worn or torn squeegee blades: Reverse or replace them. * Squeegee out of adjustment: Adjust it so the blades touch the floor evenly across the entire width. * Recovery tank full: Empty the recovery tank. * Recovery tank drain hose leak: Secure the drain hose cap or replace it. * Recovery tank cover gasket leak: Replace the gasket or properly seat the cover. * Debris caught in the squeegee: Clean the squeegee tool. * Vacuum hose clogged: Remove any debris. * Using too much solution: Adjust the solution flow at the control panel. * Foam filter cover not seated: Properly seat the cover.
H
Helen SolomonAug 5, 2025
What to do if Nilfisk-Advance Floor Machine has inadequate solution flow?
- K
  kimberly62Aug 6, 2025
  If your Nilfisk-Advance Floor Machine has inadequate or no solution flow, check the following: * Solution tank: Fill the solution tank if it's empty. * Solution lines, valves, filter, or trough: Flush the lines and trough, and clean the solution filter if they are clogged. * Solution shutoff valve: Open the valve if it's closed. * Solution solenoid valve: Clean or replace the valve.
S
Samantha OneillAug 11, 2025
Why Nilfisk-Advance Floor Machine has poor scrubbing performance?
- K
  Kristopher SmithAug 11, 2025
  If your Nilfisk-Advance Floor Machine isn't scrubbing well, here are potential reasons: * Worn brush or pad: Rotate or replace the brushes. * Moving machine too fast: Slow down your pace. * Not using enough solution: Increase the solution flow at the control panel. * Wrong brush or pad type: No answer. * Wrong cleaning chemical: No answer.
K
kristenparkerAug 15, 2025
What to do if Nilfisk-Advance Floor Machine has no detergent flow?
- C
  Caleb HernandezAug 15, 2025
  If there is no detergent flow in your Nilfisk-Advance Floor Machine (EcoFlex models only), check the following: * Empty detergent cartridge: Fill the detergent cartridge. * Plugged or kinked detergent flow line: Purge the system and straighten the lines to remove any kinks. * Dry seal cap on detergent cartridge not sealed: Reseat the dry seal cap. * Detergent pump wiring disconnected or backwards: Connect or reconnect the wiring.
Y
Yolanda MolinaAug 20, 2025
Why Nilfisk-Advance Floor Machine has no FWD/REV wheel drive?
- S
  Shaun McdonaldAug 20, 2025
  If your Nilfisk-Advance Floor Machine has no forward or reverse wheel drive, check these: * Tripped 70 Amp circuit breaker: Check for drive motor overload. * Emergency stop switch tripped: Reset the Emergency Stop Switch. * Drive system speed controller: No answer.
D
Derek WrightAug 26, 2025
Why Nilfisk-Advance Floor Machine cylindrical system has poor sweeping performance?
- N
  Nancy WhiteAug 26, 2025
  If your Nilfisk-Advance Floor Machine (Cylindrical System) has poor sweeping performance, consider the following: * Hopper Full: Empty and clean the hopper. * Brushes worn: Replace the brushes. * Bristles have taken a set: Rotate the brushes.