156Service Manual – SC401, SCRUBTEC 344 38 - Squeegee System
Removal and Installation
Spring on the Squeegee Support
Removal
1. Drive the machine on a level oor or on a hoisting system to facilitate the disassembly procedures.
2. Remove the squeege from the squeegee support (A), then lower the squeegee support by slowly to the
oor.
3. Press lighly the spring (B) then remove it with its pair of spring plastic retainers.
Installation
4. Assemble the components in the reverse order of disassembly and note the following:
◦ Mount the spring with its pair of spring plastic terminals as shown of the picture (C).
Figure 4:
A
C
C
B
OK NO!
To Next Page
Loading...
Need help?
General
