97Service Manual – SC401, SCRUBTEC 344 20 - Wheel System, Traction
Removal and Installation
Drive Wheels Controller (EB3)
1. If equipped remove the ignition key, then disconnect the red battery connector.
2. Unscrew the 4 screws and remove the electronic component compartment cover.
3. Unscrew the 2 screws (A) and pull out the Drive wheels controller (B) with his support bracket.
4. Disconnect the following connections:
◦ (C) 16 ways J1 MOLEX connector.
◦ (D) Grey M2 Drive motor faston
◦ (E) Red M2 Drive motor faston.
◦ (F) Black B - supply faston.
◦ (G) Red B + supply faston.
Figure 7:
C
D
E
F
G
E
F
G
D
C
B
A
To Next Page
Loading...
Need help?
General
