25
Before Stepping On
1. Stand behind the PTR and hold onto the Operation Bar. Center the Operation Bar, and level the foot mats. When level, there
will be 5 LED lights on the steering base, indicating the PTR is now level and in stand-by mode. If the operation bar leans in
one direction or the foot mats are not level, the LED lights on the steering base will go out, which means the PTR is not level.
You must adjust the PTR foot mats until they are level and the LED lights are all properly lit up.
2. Tap on the rear of a foot mat and you will hear a “beep”— this indicates the PTR is now in power assistant mode and will bal-
ance. The rider can now step on the PTR.
WARNING
Do not step on if the PTR is not powered on and in balance mode. You WILL fall over. NEVER step on the PTR if the Operation Bar has
been removed.
NOTICE
If the PTR looks visually level but the LED lights do not indicate it is in balance mode, DO NOT ride the PTR. Refer to the "Sensor
Calibration" section of this User Manual.
Figure 23: Make sure the PTR is in balance mode.
To Next Page
Loading...
Need help?
General