14
Assembling a New Ninebot
Assemble your new Ninebot by following the procedures in this section.
WARNING
Always power OFF your Ninebot and unplug the charging cord before cleaning, performing any maintenance procedures, or installing
any part or accessory. Failure to do so could lead to serious injury.
Preparation
Before assembling a new Ninebot, you should first find the hex driver set supplied with the product. Keep these tools handy for any
future maintenance needs or disassembly. This hex driver set features standard metric sizes, so you may use any standard metric
hand tools.
We suggest wearing gloves during assembly to help avoid minor injury and to keep the Ninebot and your hands clean.
CAUTION
Refer to the “Fasteners” chapter while following these procedures. If you are not capable of following the assembly procedures, please
contact the location where you purchased your Ninebot.
To Next Page
Loading...
Need help?
General