Need help?Do you have a question about the Ninglu AM706D and is the answer not in the manual?
General| Display Type | LCD |
|---|---|
| Humidity Range | 10% to 99% |
| Wireless Range | 100 meters |
| Temperature Range | -10°C to 50°C |
| Power Source | Main Unit: 2 x AA batteries (not included) or AC adapter (included), Remote Sensor: 2 x AAA batteries (not included) |
Explains how the weather station measures and displays data, including wind, temperature, humidity, and pressure.
Provides a diagram illustrating the system components and their connections, including sensors and main unit.
Details general specifications like display type, input/output ports, and power supply.
Lists operating and storage temperature, humidity ranges, and waterproof ratings for components.
Specifies ranges and accuracies for wind direction, wind speed, temperature, humidity, and barometric pressure.
Explains the NMEA0183 data format and transmission standards used by the weather station.
Details NMEA0183 formats for GPS data input, including GGA and VTG.
Covers Speedlog (VBW), Gyro (HDT) inputs, and Wind Speed/Angle (MWV) output formats.
Details NMEA0183 output formats for MDA, MHU, MMB, and MTA data.
Explains the main display elements, including wind speed, direction, and other parameters.
Details the function of each button on the control panel for system operation.
Covers system power on/off, power failure alarms, and alarm muting procedures.
Details how to set Gust, High Temperature, Low Temperature, and High Humidity alarms.
Covers adjusting screen brightness and configuring the printer setup options.
Explains printer output details and how to switch display modes (mode, day/night).
Details how to navigate the menu for input display, unit selection, and language settings.
States the main unit is maintenance-free and provides instructions for cleaning.
Advises on cleaning sensors, checking mounting bolts, and cable integrity.
Step-by-step guide for calibrating the wind vane after installation.
Describes table, hanging, and flush mounting methods for the main unit.
Details how to embed the main unit into a control panel for flush mounting.
Explains the installation of the AC to DC power adapter.
Details the assembly steps for the wind vane and wind cup components.
Covers space/location, U-bolt fixation, cable wiring, and calibration for the wind sensor.
Describes hung, fixed link, wall, and pipe mounting methods for the sensor.
Shows the terminal connections on the back cover for various sensors and outputs.
Illustrates the internal wiring connections between the main unit and sensors.
Illustrates external connections to Gyro, GPS, Speedlog, Printer, Repeater, and VDR.
To Next Page