Nitronic ST215 - Setting the Rotation Duration; Incision Rate Setting the Rotation Duration; Incision Rate; Setting the Rotation Duration; Incision Rate; Counterclockwise or Clockwise Rotation; no Rotation

Sdasdasdsdfdsdcdscsdcdcd
cdcsc
7
Nitronic
NitronicNitronic
Nitronic
AG
AGAG
AG
Mattenstrasse 11
CH – 2555 Brügg Tel. +41 32 373 70 70
Switzerland
Fax
+41 32 373 70 75
Setting the rotation duration / incision rat
Setting the rotation duration / incision ratSetting the rotation duration / incision rat
Setting the rotation duration / incision rate
ee
e
The rotation duration and the incision rate are selected with the same switch. The longer the setting of the rotation
duration, the shorter the incision rate. At step 0, i.e. the shortest rotation duration, the blades close very quickly. At step
9, the longest rotation duration, the blades close very slowly.
The stripping head may not be externally braked whilst running. Otherwise there is no guarantee that the blades
will close to the set diameter, particularly with step 9.
Counterclockwise
Counterclockwise Counterclockwise
Counterclockwise or cl
or clor cl
or clockw
ockwockw
ockwise rotation
ise rotationise rotation
ise rotation / no rotation
/ no rotation/ no rotation
/ no rotation
The desired rotation direction can be set with the changeover switch. This is especially important for the twisting of
stranded wires. The correct choice of rotation direction can also positively influence stripping quality when stripping
micro-coaxial cables.
ST215W only:
In the middle position, the stripping head will stop. Then you can pull off the cable while the blue LED is on. After that
the machine starts the cleaning cycle.