Nitronic ST215 - Maintenance; Changing the Stripping Blades; Cleaning; Lubrication

Sdasdasdsdfdsdcdscsdcdcd
cdcsc
9
Nitronic
NitronicNitronic
Nitronic
AG
AGAG
AG
Mattenstrasse 11
CH – 2555 Brügg Tel. +41 32 373 70 70
Switzerland
Fax
+41 32 373 70 75
Maintenance
MaintenanceMaintenance
Maintenance
The only maintenance required is cleaning of the stripping head.
Lubrication
LubricationLubrication
Lubrication
The ST215 is designed in such a way that it does not require the application of grease or oil. In order to ensure
correct function and long service life avoid contaminating the tool with greasy or oily substances.
Cleaning
CleaningCleaning
Cleaning
The waste created by the stripping should be automatically removed by the air blast.
• Clean the surface of the stripping head using a dry, clean brush only.
• Dirt on the housing or the stripping head can be removed using a cloth dampened with kerosene.
Do never use solvent like thinner to clean the machine!
Changing the stripping blades
Changing the stripping bladesChanging the stripping blades
Changing the stripping blades
The stripping blades may only be inspected and replaced by a suitably
trained person.
• Remove the power cord, foot pedal and compressed air.
• To facilitate the handling with the machine, arrange the machine with aid
of the bench clamp. See Fig. 5.
• Set the diameter setting to 0.2mm (0.008 Inch).
• Set the length setting to the hindmost position.
Fig. 5