31201 appears (that is, the number you
wish to input).
4. When you have properly entered the cor
-
rect calibration value (31201) – when
that value is displayed on the LCD read
-
out — take your finger off the button and
wait. After a few seconds, the value you
have entered will be down-loaded into
the speedometer’s microprocessor, and
the speedometer will revert back to nor
-
mal operating mode. At this point, the
manual calibration process is complete.
M200 MB4 Tow Tractor Manual No. 42975
PAGE 5-6
JULY 15, 2001
To Next Page
