PAGE 2-5
CHAPTER 1 GENERAL INFORMATION AND OPERATING INSTRUCTIONS
NMC-WOLLARD
2021 Truax Blvd. Eau Claire, WI 54703 ● P: 715-835-3151● F: 715-835-6625 ● www.nmc-wollard.com
TML-704H Maintenance Lift Manual No. 310547
2 OPERATION
FIGURE 1. SAFETY STOPS
2.3 OPERATING INSTRUCTIONS
Operator station controls are conventional in design, clearly labeled, and
conveniently grouped at the operator station. On the platform there are oodlight
switches, ignition, platform raise/lower, and stabilizer controls .
Functional and operational interlocks are provided for operator safety and
protection of the vehicle to permit long, trouble-free service.
General instructions for operation of the unit are given in this section. For a more
detailed description of engine operation, refer to the manufacturer's manuals
provided with each unit.
SAFETY STOPS MUST BE ENGAGED before working beneath
the platform, in the engine compartment or for maintenance/repair activities that
involve removing or disconnecting platform lift system hydraulic components.
Raise platform until frame rollers are foward of safety stops, then push operation
knobs in and lower platform so frame rollers rest against safety stops. See gure 1.
If the platform were to fall, it will cause serious injury or death.
2.3.1 Daily Inspection
Before putting the unit into service and each day before operating the unit,
always walk around unit and make the following checks:
SEPTEMBER 01, 2015
Property of American Airlines
To Next Page
Loading...
Need help?
General